3D Post - 24"        
 
FENCES:
1
Use bailing wire or zip ties, feed the wire or zip ties through the holes on the type of the 24" 3D Post.
2
Attach to the fence, tighten until snug.
3
Repeat steps one and two on the bottom of the 24” 3D Post.
 
 
TREES AND WOODEN POLES:
1
Hold 24” 3D Post flush to tree or wooden pole.
2
Attach using screws through the holes on the top and bottom of the 3D Post.
   
T-POSTS & SLIP OVER POLES:
1
With a utility knife cut the bottom section and remove excess (see guide on bottom, back side)
(CAUTION: When cutting with knife or saw always remember to cut away from your body.)
2
Slip 24" 3D Post over t-post, through newly cut bottom hole, until 3D Post bottoms out on T-post.
3
Place bailing wire or zip ties through holes at bottom of 3D Post and around the T-post, tighten until snug.
3D Post - 60"
 
T-POST AND SLIP-OVER POLES:
 
Slide 60" 3D Post over t-post, fence post or u-channel post. Use bailing wire or zip tie through the holes in the bottom of the 3D Post to secure to T-post or fence post.
   
STAND ALONE:
 
Dig an 8" deep hole approximately 4" diameter. Expand the flanges at the bottom of the 60" 3D Post outward. Place 3D Post 60"in hole and back fill, firmly compacting the soil around the post base. For a more permanent placement add cement to the hole.
 
©2011 3D Post. 3D Posts makes high quality three dimentional signs like "No Trespassing" and "No Hunting" for property notices.
  FOLLOW US: